How Much Working Space Do You Need on a D28 Welding Table?
A frame can fit on a welding table and still leave too little room to fixture it. Before choosing a D28 table size, sketch the workpiece, the tooling around it and the space needed to take the finished assembly out. That sketch gives you a better starting point than the part dimensions alone.
1. Draw the part and its locating points
Start with the largest job you expect to run regularly. Draw its footprint in the position you plan to weld it. Mark the edges or features that will locate the assembly, then show where the stops, squares and supports need to sit. If you plan to rotate or flip the part for a second operation, check both orientations.
2. Add space for the clamps and their mounting holes
Draw the full base of each tool and mark the hole it needs. A clamp pad may reach the part while the base lands between holes or too close to an edge. Check the proposed tabletop hole drawing and the reach of the tooling you intend to use. Leave room to open and remove each clamp, and check where the operator needs access for welding and inspection.
3. Check a common layout on paper
Suppose a rectangular frame measures 1,650 × 780 mm. On a 2,000 × 1,000 mm top, centring it leaves 175 mm at each end and 110 mm on each long side. If your stop and clamp arrangement needs 140 mm along one long side and 60 mm along the other, try shifting the frame before selecting a larger table. Shifting it 30 mm gives you 140 mm on one side and 80 mm on the other. Check that the shifted positions align with usable holes and leave enough access. These figures illustrate the layout check. Actual clearance depends on your tooling.
For a size reference, the TA282010N D28 welding table has a 2,000 × 1,000 mm working surface and a 100 × 100 mm tabletop hole grid. Use the drawing for the model you plan to order when checking specific hole positions.
4. Make sure the finished assembly can come out
Trace the removal path with the locating hardware still in place. A tall stop or angle bracket may block an assembly even after the clamps are open. Decide which stops need to swing away or come out and how the part will be handled under your workshop’s procedures. If the same obstruction appears on every cycle, revise the fixture layout before ordering the table and tooling.
What to include in your quotation request
- A drawing or sketch showing the largest recurring assembly and its orientation.
- The locating edges, clamp positions and faces that need welding or inspection access.
- Any change of orientation during the job and the path used to remove the assembly.
- Your preferred table size and hole pattern, plus any tooling you already own.
Use the NewWeldTable configurator to compare table sizes. If two sizes look workable, send both with your sketch and ask for the tabletop hole drawings so you can compare the mounting positions before you order.